Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
Dear Friends
We have undergone a change in our domain name recently.
Post which users are not able to login to access point.
Earlier we were using abcd\employeenumber as our username. Now we have pqrs as our domain.
We have provided the path LDAP://pqrs.in in the systems -> tab of QMC.
When we try to provide the document CALs n User Document tab for a document if we search a particular EmpNumber ,it shows up. (This shows we are able to connect to the Active Directory and assign the CALs to the user) But domain name is not displayed, only the employeenumber is displayed.
Now when the user tries to login to access point the username and password goes blank.
Kindly help if we are missing any steps to allow access for the users to access point.
Kindly let me know if any more information is required .
Thanks & Regards
Niranjan
Hi,
What is the error which user is getting. Also tell us how are they trying to login. (Within Domain or out side domain)
Also check if you can login on access point on server with the user.
Make sure that you try both the below thing in username
Only username and Domain\Username.
Regards,
Kaushik Solanki
Hi Kaushik
1)When the user tries to login to access point the username and password goes blank after loading for few seconds.
2)Not able to login to the access point on server.
3)Tried with both only employeenumber and domain\employeenumber.
Is the authentication not done ? Any other settings which is being missed?
Thanks & Regards
Niranjan
Hi,
Restart the DSC service, Qlikview Directory Service Connector.
Hi,
So following changes.
QMC->System -> Setup - >Web Server -> Authentication -> Authrntication -> Login.
QMC->System -> Setup - >Web Server -> Authentication -> Login Address -> Alternate login page.
Cliek Apply.
And use below URL login on accesspoint.
Http://Servername/Qlikview/Formlogin.htm
Regards,
Kaushik Solanki
Hi Kaushik
Alternate login page radio button is checked.
But in QMC->System -> Setup - >Web Server -> Authentication -> Authrntication -> Login. there are no credentials entered.
Which login credentials should be mentioned here.
Thanks & Regards
Niranjan
Hi,
It is also the Radio Button.
QMC->System -> Setup - >Web Server -> Authentication -> Authentication -> Login.
On the same page where you did alternate login page setting.
Regards,
Kaushik Solanki
Hi
Done but same issue again. While logging into access point, the username and password goes blank.
Hi,
Make sure that all the services are running properly.
Regards,
Kaushik Solanki
Please check whether you provide access to user or not?
If yes check Go to System ->Qlikview Server-->CAls tab --->General tab
and check there is radio button active for Identification by username.
Hope it helps
Dear Mohit
I do not find the CALs tab in the QlikView Server.
Regards
Niranjan