"No Server" Message in Qv 11

[#1]

Good day everybody.

i use QV (v11)
i'm facing a "no server" error some time i reach the access point.
i found that QVS@qlickview-shoab in Qlikview Management Consoel is disconnected at the same time.

for Solving the Problem i must restart QVS service in windows services.
then it work correct for two or three daye.
and repeat the problem.

can somebodody help me please?

[#2]

Hi Fred

No worries on the Sara name, I've been called much worse.

Good luck.

/Rasmus

[obriened83]

Hi Fred

     Did you find a solution to this issue?

Kind Regards

Eamonn

[#4]

hi Obriened

I'm sorry

No, The issue not solved Still, and i try to find a solution for this problem.

tanks for your attention

Fred

[#5]

Have you check if the proxy is making you the trubel?

I had a simillar issue and it was the proxy

[obriened83]

Hi

We figured out what caused our issue

NUMA on our Servers was enabled which caused the Sever Instability

To ensure that NUMA is disabled on your Qlikview Server do the following:

1) Stop all Qlikview Services

2) Open up the Settings.INI file located in C:\ProgramData\QlikTech\QlikViewServer\

3) Place the command EnableNumaRoundRobin=1 right below [Settings 7]*

4) Close the INI file and Start all Qlikview related Services again.

*When you restart services it is a good idea to open open the Settings.ini file again to see if the EnableNumaRoundRobin=1 was implemented. Sometimes if the command is placed at

the end of the INI the command gets deleted when the Services are started up again.

If you have any queries with the above I would be more than happy to help.

Thanks very much.

Kind Regards

Eamonn

[#7]

hi

our problem solved by update version of qlikview server to 11.2 SR11