Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
Hi All,
I have a large data table and I'm trying to put together an expression in a LED display chart, but I just can't get it to work!
Two of the fields are Service and Build...
Service Build
Service A B
Service B B
Service B F
Service C F
Service D B
Service D F
etc.
I need the LED display to show the count of the number of services that have a build of both B and F.
Any help gratefully received! Thanks.
Hi ,
If i understood clearly for services listbox u want to show the count of B and F in the same list box
Take services as listbox, then go the properties and expression tab of the listbox and add an expression
=count({<Build ={'B','F'}>}Service)
or try this
=if(match(Build,'B','F'),0,count(Service))
Hi Shree909, Thanks for the reply.
I'm trying to get the number of services that are listed against both the builds - B and F.
But not those that are just B or F.
So, in the small example above, the result should be just 2... Service B and Service D.
Regards
You may use And-Mode listbox. The Qlikview Reference manual explains this in detail.
Thanks Krishnamoorthy.
In the list box I created using the advice from shree909 the And-Mode checkbox is greyed-out.
Also, I'm trying to get just one value returned, displayed as an LED gauge chart (I dont need the service(s) displayed.
The And-Mode checkbox will be available (not greyed-out) when the conditions for such listboxes are met. The conditions are discussed in the Reference Manual.
