Total in straight table

[vikasmahajan]

Dear all

Please refer attachment of  h1.jpg  in this I have created straight table base on conditions  high value and high growth ,

quadrant wise report base on conditions if ( ) used in expression but total is not appering in straight table.

any one have idea how to arrive the total.

Regards

Vikas

[#2]

Please, paste the expression you used. An if condition may cause problems in the total, as qlikview might find impossible to aggregate the condition used. Is it impossible to replace the if with a set analysis?

[#3]

Hi Vikas,

Your attachment is missed from your post. If possible, please attach your application aswell.

[tresesco]

Give a try:

Change the 'Total Mode' (under expression tab) to 'Sum of rows'

Note: this depends on your expression and requirement

[er_mohit]

in dimension limit tab for that check on Show total

hope it helps