Setting slider to a value instead of zero through a variable

[#1]

Hello,

Rebate % calculated is 2.63%. I am trying to build what-if analysis to see what happens to margins which i increase or decrease rebate %.

To do this, i have used a slider and associated the slider to a variable. instead of assigning 0 value to the variable, i would like assign 2.63%.

if i assign the rebate % formula in variable editor, the value is not retained when i change the slider

Any ideas?

Thank you,

Vishal

[venkatg6759]

check the attached qvw. Hope it helps.

Thanks ,

[#3]

Hi Venkat,

my rebate would not be 2.63% constantly. it would change based on selection and the slide should automatically adjust to the value.

Thanks,

Vishal

[venkatg6759]

Can you try to paste the formula  that you are using to calculate your rebate

[#5]

You can use an action to reset the variable if that's what you are looking for.  Take a look at the attached document and see if it's what you are looking for.

[#6 · Accepted solution]

Thanks Rebecca and Venkat.

Instead you setting variable value to constant, i have set the variable to rebate % calculation and it started behaving dynamically.

Cheers!

Vishal