Unlock a world of possibilities! Login now and discover the exclusive benefits awaiting you.
Dear Experts
I created qvd files and I copied the path of the files from the explorer. I double checked to make sure that the path is correct. However, when I run the data model to load the data from qvds, it gives me an error saying the file cannot be read and the file cannot be found. What could be the possible reason ?
Pease advise.
Mahlatse
In the script editor click the Table Files button, then you can navigate to and select your required qvd & complete the rest of the wizard.
Then compare the generated script to what you had done manually, spot the difference and then you will know where you had gone adrift.
Best Regards, Bill
Please check if you´re using (qvd) at the end of command.
LOAD
A,
B
FROM $(PATH)\yourqvd.qvd(qvd);
hi,
you can check the Qvd file name.
and the syntax to load qvds are as follows:
load *
From [PATH]/[QVD NAME].qvd(qvd);
Please check above two conditions.
-NIlesh
Mahlatse
In the script editor click the Table Files button, then you can navigate to and select your required qvd & complete the rest of the wizard.
Then compare the generated script to what you had done manually, spot the difference and then you will know where you had gone adrift.
Best Regards, Bill
yes, I am using (qvd) at the end of command, Here the error message:
Cannot open file 'C:\Qlikview\Hardcat\QVD\hc_outlinetree.qvd' The system cannot find the file specified.
"OutlineTree":
LOAD
X,
Y,
Z
FROM
Thank you! My problem is resolved
Mahlatse
Good to hear you are back on the road.
Best Regards, Bill