topic Re: Line Layer Start/End point in GeoAnalytics

Line Layer Start/End point

mireyamunoz — Thu, 20 Sep 2018 04:28:24 GMT

Hi Everyone,

I'm working with a dispatch table that contains only one start point going to many ends points, where several of them repeat it more than once. Each one of these has an Operation number that repeats from 1 to 5 times, but the start/end point remains the same

Table example

N°op

Start point

Lat_Start_Point

Long_End_Point

End Point

op1

Puerto San Antonio

-33.58333

-71.61667

Chicago

op2

Puerto San Antonio

-33.58333

-71.61667

Chicago

op3

Puerto San Antonio

-33.58333

-71.61667

Texas

op4

Puerto San Antonio

-33.58333

-71.61667

Texas

op5

Puerto San Antonio

-33.58333

-71.61667

California

At Location source, I tried with almost all possibilities except Dimension as I'm putting N° op in there. Even I tried with an if condition, but either work and still not seeing the lines from start to endpoint

Any thoughts on this?

Regards in advance.

Mireya Muñoz

Qlik GeoAnalytics‌ bps‌

Re: Line Layer Start/End point

Lisa_P — Thu, 20 Sep 2018 06:00:03 GMT

Hi Mireya,

I can get your data to display on map, but you don't really have any measures to show color or width.

My settings are:

Line Layer

Data > Dimension > Noop

Location

Also add in a point layer for your start point and another for your end points

Re: Line Layer Start/End point

Patric_Nordstrom — Fri, 05 Oct 2018 09:12:58 GMT

Hi,

In addition to Lisas answer, in QGA you cant mix coords and lookups in the line layer.

So, either add ',CL' to Puerto San Antonio in the indata to make non ambiguous.

Or add coords the end points and use coords for both start and end.

Thanks,

Patric