topic ERROR: Cannot apply filter Filters in Qlik NPrinting

ERROR: Cannot apply filter Filters

leonardo_sudo — Wed, 25 Sep 2019 18:40:54 GMT

Hi folks,

I'm noob NPrinting and English :s , and i have a question.

I'm usign two filters in a report, and when run preview in NPritning 18 Designer shows error:

Using the same filters in a Qliksense App, my fact table is empty.

I think that even empty, the NPrinting should generate an empty report. And no show error message.

Re: ERROR: Cannot apply filter Filters

Ruggero_Piccoli — Thu, 14 Mar 2019 15:51:01 GMT

Hi,

If you are using a numeric value (for example you are filtering Year =2019) remember to set the drop down menu to Numeric Value is.

Refer to https://help.qlik.com/en-US/nprinting/February2019/Content/NPrinting/ReportsDevelopment/Static-dynamic-filters.htm#anchor-2

When you post a question, please remember to add the complete version and where possible some screenshots (for example one of the filters).

Best Regards,

Ruggero

Re: ERROR: Cannot apply filter Filters

leonardo_sudo — Thu, 14 Mar 2019 16:45:42 GMT

hi @Ruggero_Piccoli

I think this same problem

https://community.qlik.com/t5/Qlik-NPrinting-Discussions/NPrinting-Stop-sending-emails-when-no-report-is-generated/td-p/52577

Only Feb/2019 dont sent email when report error?

Re: ERROR: Cannot apply filter Filters

Ruggero_Piccoli — Fri, 15 Mar 2019 08:46:14 GMT

Hi,

From February 2019 Release Notes:

New parameter that configures whether emails send when reports fail
If the reports attached to an email fail to generate, the default behavior is for the email to send with an error
message.
Uncommenting the new parameter <add key="disable-failure-email-sending" /> in the scheduler.config file
stops emails from sending when report generation fails. If reports are not sent an error will be logged.
If you enable this parameter:
- If all reports for a user in a task are correctly generated, the user will receive the email.
- If only some of the reports for a user in a task are generated the user will receive an email with only
the generated reports.
- If the generation of all reports for a user in a task fails they will not receive an email.

Best Regards,

Ruggero