topic Re: How to increase Parallel table Loads inside a Task in a repctl CLI call in Qlik Replicate

How to increase Parallel table Loads inside a Task in a repctl CLI call

VSSARDESAI — Tue, 30 May 2023 14:58:36 GMT

I am trying to run the Qlik replication task from repctl.

I am finding that the Job is executing the table loads in a serial manner.

How do I change/ Increase the parallelism through the repctl command?

Is there a Task level configuration that will allow repctl to run the task in multithreads.

Re: How to increase Parallel table Loads inside a Task in a repctl CLI call

Dana_Baldwin — Tue, 30 May 2023 16:58:09 GMT

Hi @VSSARDESAI

The task will run according to how the task settings are defined. On the Full Load \ Full Load tuning screen you can define how many tables will load at the same time, the default is 5:

Full Load Tuning #Full Load Tuning | Qlik Replicate Help

Some endpoints also allow you to load individual tables in parallel:

Parallel Load | Qlik Replicate Help

Keep in mind that the number of connections & resources used on your endpoints will increase as you increase these values.

If this helps, please mark it as a solution & like it to make it easier for others to find.

Dana

Re: How to increase Parallel table Loads inside a Task in a repctl CLI call

Heinvandenheuvel — Wed, 31 May 2023 18:01:27 GMT

>> I am finding that the Job is executing the table loads in a serial manner.

HOW did you come to that conclusion? 'show your work!'.

Perhaps attach an reptask_xxx.log? If possible provide (simplified?) task JSON, notably the task settings section?

Does it behave differently when started from the UI? That would be hard to believe, but provide a second log?

How (exactly) did you run the EXECUTE command? Maybe- just maybe- you forgot the data directory and the wrong task was run? Did try with CONNECT; before the execute (I don't recall whether that is needed, I think not).

Hein.