topic Re: How to set different workload for Rim nodes in Management & Governance

How to set different workload for Rim nodes

Thu, 20 Apr 2017 07:41:30 GMT

Hi Gurus,

I've just installed QS with shared persistence. Both the Rim nodes and central nodes are added to the 'Load balancing'.

But how to track the balance among these nodes, and how to manually set the workload balance? For example, these apps should reload on this node, the others go to a different node.

Thanks~

Re: How to set different workload for Rim nodes

kaushiknsolanki — Thu, 20 Apr 2017 08:09:33 GMT

Hi,

Not sure but check below link. Hope it will help some what.

http://help.qlik.com/en-US/sense/3.2/Subsystems/ManagementConsole/Content/configure-load-balance-to-isolate-development-nodes.htm

Regards,

Kaushik Solanki

Re: How to set different workload for Rim nodes

Fri, 21 Apr 2017 03:47:19 GMT

Hi Kaushik, thank you for the article.

In the example in the article, after I add these Production nodes into the 'Load Balancing', how to config them?

I mean could I config that certain app should only reload on a certain node?

Regards,

Re: How to set different workload for Rim nodes

kaushiknsolanki — Fri, 21 Apr 2017 05:12:39 GMT

Hi,

Yes you can do that to, but for that you will have to right the rules.

The link has a sub link which will take you to the rules.

Regards,

Kaushik Solanki