topic Bar chart colour by key figure in Management & Governance

Bar chart colour by key figure

JuDu1905 — Mon, 07 Jun 2021 08:28:14 GMT

In this bar chart I would like to set the colours so that as soon as a key figure is above 0 it appears green, as soon as it is below 0 it should be red. This classification should apply to every key figure.

What setting can be used to do this? A general limit cannot be set for this type.

Re: Bar chart colour by key figure

chrismarlow — Mon, 07 Jun 2021 18:41:49 GMT

Hi,

If by key figure you mean the your measure (looks like a sum), I think then under Appearance you would set colors off Auto to Custom & then set By Expression, similar to below;

Cheers,

Chris.

Re: Bar chart colour by key figure

JuDu1905 — Tue, 08 Jun 2021 19:38:55 GMT

Exactly, I understand everything with an if-formula, only the input "mea" is inconclusive with me. There are different measures, for me they don't always colour after the first key measure, that shouldn't be the case.

Re: Bar chart colour by key figure

chrismarlow — Fri, 11 Jun 2021 13:14:10 GMT

Hi,

I am not sure I follow. Do you mean your bars have different formulae? Can you share the dimensions and expressions for your chart and some dummy sample data?

Cheers,

Chris.

Re: Bar chart colour by key figure

JuDu1905 — Sat, 12 Jun 2021 15:32:03 GMT

Exactly, it is other formulas that are shown in the diagram.

The total deviation is + 33.541, so this should be shown in red.
The result that follows is approx. -17,000 and is called the prod deviation. Since this is negative, it should be shown in green.
The third measure is the backlog deviation and is +301.58. It should therefore be shown in red again.

I would like to mark different measures in red or green, based on the limit 0.

Thanks!

Re: Bar chart colour by key figure

chrismarlow — Mon, 21 Jun 2021 18:07:52 GMT

Hi,

Apologies been busy but just spotted your reply to this.

Could you try using ValueList to fool this into thinking you only have 1 measure, so dimension something like;

ValueList('1','2')

And single measure;

pick(match(ValueList('1','2'),'1','2'),sum(mea1),sum(mea2))

Then color;

if(pick(match(ValueList('1','2'),'1','2'),sum(mea1),sum(mea2))<0,Red(),Green())

I've attached an app showing the above.

Cheers,

Chris.