topic Re: AD User login Failed - Qlik sense Multi Node Server in Management & Governance

AD User login Failed - Qlik sense Multi Node Server

shraddha_g — Tue, 06 Sep 2016 04:26:20 GMT

Hello all,

I have installed Multi node Qliksense Server and done setting for Virtual proxy for Load balancing. AD User Directory Connection has been created and synced, which worked successfully.

I can Access development node by using https://<Server Address>/dev/hub.

Now, I can login by using Local Server User details. But I am unable to login on QMC/Hub by using AD user login credentials.

Attached is the screenshot of the error.

Following are the references I used for installation:

Qliksense Multi Node Setup Guide (DFAFT).pdf
http://help.qlik.com/en-US/sense/3.0/Subsystems/PlanningQlikSenseDeployments/Content/Server/Server-Deployment-Scenarios-Multi-Node-Site-Examples-Prod-Dev-Sync.htm

Re: AD User login Failed - Qlik sense Multi Node Server

korsikov — Wed, 07 Sep 2016 06:59:08 GMT

add your QS node is a member you AD?

IF it's not you can't auth your AD users.

Re: AD User login Failed - Qlik sense Multi Node Server

shraddha_g — Wed, 07 Sep 2016 07:20:43 GMT

Hi Alexander,

Thank you for your reply.

I can login by AD user when there is Single node Qlik sense installation.

After adding Rim node, AD user is not able to access Hub/QMC. Error Shows 'User is not authenticated'.

Am i missing any settings for User directory after configuring RIM node?

Regards,

Shraddha

Re: AD User login Failed - Qlik sense Multi Node Server

korsikov — Thu, 08 Sep 2016 12:12:00 GMT

is your RIM node server is a member AD?

Re: AD User login Failed - Qlik sense Multi Node Server

shraddha_g — Fri, 09 Sep 2016 02:53:47 GMT

Yes, it is.

Re: AD User login Failed - Qlik sense Multi Node Server

korsikov — Fri, 09 Sep 2016 11:43:45 GMT

Can you log in on this server in RDP, SMB and other using your Domain credetials

Re: AD User login Failed - Qlik sense Multi Node Server

shraddha_g — Mon, 12 Sep 2016 04:21:00 GMT

Yes, I have tried all this using Domain Credentials and it works.

Re: AD User login Failed - Qlik sense Multi Node Server

shraddha_g — Tue, 13 Sep 2016 04:13:14 GMT

Issue is resolved.

This is because the below mentioned setting was not enabled for the “Authenticated Users”.