https://community.qlik.com/t5/Integration-Extension-APIs/Mashup-delay-load-of-hyper-cube/m-p/1628766#M11401 <P>I am not sure if this is the easiest way to do this so please feel free to educate me. I have to create a table in HTML using data from Qlik exactly like an older table our CEO is used to. I have done that with a simple hypercube. Now it needs to drill one level down. I did that with a second hyper cube&nbsp; but the problem is both hypercubes run when the page is loaded. Is there a way to delay the second hypercube from loading until a top level is clicked? This should also make it a bit quicker because it will only load the first hypercube at launch.&nbsp;</P> Sat, 16 Nov 2024 04:33:08 GMT danelooman 2024-11-16T04:33:08Z https://community.qlik.com/t5/Integration-Extension-APIs/Mashup-delay-load-of-hyper-cube/m-p/1628766#M11401 <P>I am not sure if this is the easiest way to do this so please feel free to educate me. I have to create a table in HTML using data from Qlik exactly like an older table our CEO is used to. I have done that with a simple hypercube. Now it needs to drill one level down. I did that with a second hyper cube&nbsp; but the problem is both hypercubes run when the page is loaded. Is there a way to delay the second hypercube from loading until a top level is clicked? This should also make it a bit quicker because it will only load the first hypercube at launch.&nbsp;</P> Sat, 16 Nov 2024 04:33:08 GMT https://community.qlik.com/t5/Integration-Extension-APIs/Mashup-delay-load-of-hyper-cube/m-p/1628766#M11401 danelooman 2024-11-16T04:33:08Z