How to setup QlikView Server Cluster

Andre_Sostizzo — Tue, 22 Jun 2021 14:36:26 GMT

Note: This article will assume Installation is done on Windows Server 2008 machines.

Prerequisites:

Following requirements have to be met before starting the QlikView Server cluster configuration:

A QlikView Server license allowing QlikView Server clustering
That means that the QlikView Server LEF must consist of an entry “NUMBER_OF_CLUSTER_NODES;X;;” where X is 2 or higher
Accesspoint (based on IIS or QlikView Web Server), Management Service, Qlikview Distribution Service, Directory Service Connector are already installed on QlikView system in the network
A domain user to run the QlikView services on every machine is available
A Windows Network-Share

All QlikView Server cluster nodes need read /write access to the following data centrally stored:

Server status files aka .pgo
QlikView Documents aka QVWs
QlikView Server Logs such as audit, session, performance, event logs

Step-by-Step Installation

Prepare the shared device:

Create folders for the files accessed by every QlikView Server cluster node:
- QvRoot for the .pgo-Files
- QvMount for a Mounted Folder
- QvLogs for the Logfiles
- QvExtensions for the extensions
- QvTemp for the temp files
Prepare the cluster nodes:

On each planned QlikView Server cluster node perform the following configuration:
1. Login as Administrator
2. Turn Off Windows Firewall
3. Deactivate Internet Explorer Enhanced Security Configuration for Administrators
4. Add Domain User the QlikView services should use to Local Administrators Group
5. Start QlikView Server setup and install feature “QlikView Server”
  
  NOTE: Do not install any other services such as QlikView Management Service on multiple nodes in the cluster!
6. During the setup check that you will specify the QlikView service account later
7. Do not restart the system immediately after install is completed, but
  - Add QlikView service user to “QlikView Administrator Group”
  - Change Logon setting of the QlikView Server Service to the QlikView Service user
8. Restart the system
Configure QlikView Server-Cluster in QlikView Management Console
1. Open QlikView Management Console and register QlikView Server licence with activated cluster nodes
2. Add first QlikView Server cluster node below QlikView Servers
3. Switch Root,Mount,Logs,Extensions and Temp Folders to Shared Device folder pathes using UNC-syntax (i.e \\Fileshare\QvRoot)
4. Press Apply and let QlikView Management Console initiate restart of QlikView Server service
5. Add each additional QlikView Server cluster node and activate them by entering control number of the registered QlikView Server license.
6. Press Apply and let QlikView Management Console initiate restart of QlikView Server service on all nodes
7. Verify all QlikView Server nodes are running
8. Configure LoadBalancing feature in the QlikView WebServer Settings AccessPoint tab.

article How to setup QlikView Server Cluster in Official Support Articles

How to setup QlikView Server Cluster

Prerequisites:

Step-by-Step Installation