topic Re: Always One selected value Issue After reload the Document in QlikView

Always One selected value Issue After reload the Document

kakani87 — Thu, 08 Mar 2018 09:20:26 GMT

Hi Floks,

When i check Always One Selected value in a listbox this is working fine.

but when i reload the document this Always One Selected value is getting disabled.

Any suggestions

Regards,

Kishore.

Re: Always One selected value Issue After reload the Document

jonathandienst — Thu, 08 Mar 2018 09:33:32 GMT

The "Always One Selected" property is a property of the field, even though it is set as a listbox property. So it is part of data rather than layout.

If the field is not loaded (for example, opening the file in no-data mode) then the property will be lost. If the field is loaded with no values (for example, all null), then the property will also be lost, as the property cannot achieve the "one selected" requirement.

Re: Always One selected value Issue After reload the Document

vineetadahiya12 — Thu, 08 Mar 2018 09:34:53 GMT

Are you facing the issue when you do a reload on desktop or when you are viewing it in Web Browser?

Re: Always One selected value Issue After reload the Document

kevinalvino — Thu, 08 Mar 2018 09:40:53 GMT

Hi kakani87

This is based on my experience, but if you select a list box and activated the always one selected value, it's working. Even after that you try to reload it's working. There are exception though, when you do reload the same data source with new changes, there's possibly the starting value for the always one selected value is no more in the data source, the Always one selected value must be re-applied.

Regards,

Kevin

Re: Always One selected value Issue After reload the Document

chinnuchinni — Thu, 08 Mar 2018 09:45:00 GMT

where did you test it ? server level or desktop level ?

Re: Always One selected value Issue After reload the Document

kakani87 — Thu, 08 Mar 2018 10:04:13 GMT

Yes Vineeta ...

This problem is in desktop

the Filter is an inline load as follows

Load * Inline

[

value,Descp

1,'InvoiceAmount'

2,'InvoiceCount'

3,'SalesReturns'

4,'ChequeBounce'

5,'NetSales'

]

;

Re: Always One selected value Issue After reload the Document

kakani87 — Thu, 08 Mar 2018 10:05:08 GMT

Desktop level with inline load the filter is considered

Load * Inline

[

value,Descp

1,'InvoiceAmount'

2,'InvoiceCount'

3,'SalesReturns'

4,'ChequeBounce'

5,'NetSales'

]

;

Re: Always One selected value Issue After reload the Document

kakani87 — Thu, 08 Mar 2018 10:08:50 GMT

Filter is an inline load so this might be an issue

Re: Always One selected value Issue After reload the Document

chinnuchinni — Thu, 08 Mar 2018 10:24:12 GMT

for inline load also it will work properly. once close your application and run it again it will work as usual hope fully.

i tested it lot of times.its worked for me properly

Re: Always One selected value Issue After reload the Document

kakani87 — Thu, 08 Mar 2018 10:30:49 GMT

Yes praveen now this is working fine.

Even i'm confused with this Because some rare scenarios faced by me yesterday as well regarding a table load and after a while the same script started loading the table .

Re: Always One selected value Issue After reload the Document

wonkymeister — Fri, 16 Jul 2021 11:50:31 GMT

Thanks for this! Fix worked. In 8 - 9 years dev'ing with Qlik i've never had this issue until today!