topic Re: Set session time out for a particular report in AccessPoint page in QlikView

Set session time out for a particular report in AccessPoint page

apoorvasd — Mon, 26 Jan 2026 18:19:17 GMT

Hello Everyone,

When a report is opened in AccessPoint page and left unused for say, around 30 minutes, I see an error message (PFA). So every time when this happens, I need to refresh the page. Is it possible to remove such kind of time out for a particular report in QlikView?

Currently in QMC, session time out is set to as shown in the picture below. This property is applicable to all the documents that is in AccessPoint.

However for a particular report, I have left these options blank, to make sure to apply this document setting and not the server time out setting. But I don't think this is working as I still see that the report closes after a particular amount of time even after having this setting. I think the server setting is overriding the report setting (not sure though).

Any help on this?

Thank you.

Re: Set session time out for a particular report in AccessPoint page

Peter_Cammaert — Thu, 17 Aug 2017 13:50:46 GMT

The QMC Help explains that when both values are available (i.e. individual and global timeout settings), the lowest of the two will be used for a particular document. Since you try to increase the session timeout for a particular document by setting the local values to blank (which is equal to 0, meaning no limit) I don't think the QlikView server will cooperate unless you first set the global settings to blank (or 0), and start assigning std values to all documents for which you want the default 1800 seconds timeout to still apply.

Re: Set session time out for a particular report in AccessPoint page

apoorvasd — Fri, 18 Aug 2017 06:09:50 GMT

Hi Peter,

Yes, that's right! It helped me.

Thank you.