topic Generel Script Error in QlikView

Generel Script Error

Mon, 26 Jan 2026 18:19:17 GMT

Hi,

We are using QlikView 9 SR5 and frequently the Reload task fails in the middle with the message "Generel Script Error" . This task has ran successfully previously without issues.

What is causing this error message to be visible and how can be avoid this.

Thanks,
Karthi

Generel Script Error

Wed, 28 Jul 2010 20:05:13 GMT

Hi Karthi,

That error message is too "General" to give an answer without additional information. Here are two ways to determine which line of your load script is causing your issue.

1) Try running your load in Debug mode and step through your load script until you find the statement that is failing.

2) Or you could try to insert "script exit;" in your script to force the load to stop at a certain point. If your load works successfully, move "script exit;" later into the script and run again, but if the load fails move "script exit;" closer to the start of the script.

Using either of these methods, you will be able to isolate the statement that is causing the General Script Error. If you can post the statement we will be able to help you debug your script.

Thanks,
Andy Rizzuto

Generel Script Error

suniljain — Thu, 29 Jul 2010 12:16:57 GMT

Dear Friend,

can you post the script ?. so that it clear us what is exact proble.

Regards

Sunil Jain.