topic Triggered task stopped working in QlikView

Triggered task stopped working

jduarte12 — Mon, 26 Jan 2026 18:19:17 GMT

Good afternoon,

In our company, we are running QlikView Server 11 SR1 on Windows Server 2008 R2 Enterprise 64-bit.

In the management console, we have defined a series of tasks:

Task A: Load a .qvd file hourly

Task B: Distribute a .qvw document when Task A has succeeded

Task C: Distribute other .qvw document when Task B has succeeded

Tasks D, E and FE: Reload other .qvw documents when Task C has succeeded

This working fine until the beginning of this week, when we noticed that Task C was not being performed. That is: tasks A and B were successfully run after having been triggered but task C simply was not performed: there was no e-mail alert nor failure.

To solve this question, we have deleted all the triggers and defined them back from zero. However, the problem is not solved yet: tasks A and B are run as expected but task C is run only for the first or second hourly trigger. After that, the column "Started/Schedulled" shows "Not schedulled" and not the "When Task B has Succeeded" that should be there.

This is most bizarre since our task-series always has been triggered without problems and this issue appeared without noticeable reason.

So, according to your experience, I would like your help in order to solve this problem, as by now we have to perform the reloads manually.

Thanks in advance.

Best regards,

João Duarte

Re: Triggered task stopped working

jduarte12 — Fri, 18 Oct 2013 08:33:33 GMT

I contacted Qlikview Support about this issue, which was reported to be a known bug.

After doing what QlikView Support recommended, the problem seems to have been solved.

Re: Triggered task stopped working

Anonymous — Fri, 18 Oct 2013 09:24:48 GMT

Joae

Could you share what was recommended ?

Best Regards, Bill

Re: Triggered task stopped working

jduarte12 — Fri, 18 Oct 2013 09:52:21 GMT

Of course.

Basically, the idea is change the QMSChunkSize parameter in

C:\Program Files\QlikView\ManagementService\QVManagementService.exe.config

Where appears

they recommend to change "100" to a lower value, such as 20. Then, save the .config file and restart the QMS service.

Best regards,

João Duarte

Re: Triggered task stopped working

Anonymous — Fri, 18 Oct 2013 09:53:28 GMT

Joao

Many thanks for the info.

Best Regards, Bill