topic Re: How to unhide hidden script for all the tabs in QlikView

How to unhide hidden script for all the tabs

Tue, 09 Oct 2012 13:59:23 GMT

Hi everyone,

I have question relative to the hidden script.

In my QlikView document I must hide script code for all the tabs, so I did it, but I would like to know if there is an easy way to unhide all the tabs at the same time.

I would like to unhide all the script code to reload the document and get error messages, and I dont want to copy all the hide script tab by tab and paste it an unhide tab before reload.

Thanks a lot

Re: How to unhide hidden script for all the tabs

erichshiino — Wed, 10 Oct 2012 03:26:54 GMT

Hi,

Maybe you can use document settings -> Security - > Show progress for hidden script to check the progress and identify erros.

Then, after you debug it you can disable this option again.

Hope it helps,

Erich

Re: How to unhide hidden script for all the tabs

Wed, 10 Oct 2012 11:32:02 GMT

Thanks a lot for your answer.

I have tried to check this option and Apply changes, but then I can see this option unchecked, and log file does not show too much information.

Thanks

Edu

Re: How to unhide hidden script for all the tabs

erichshiino — Wed, 10 Oct 2012 12:18:34 GMT

I had a similar problem before with other settings.

Did you start this application in an older qv version and then migrated to a newer one?

It happened to me in this case...

Back then, I had to reopen it in the older version to be able to use the setting properly...

I'm not sure if this has been fixed...

Regards,

Erich

Re: How to unhide hidden script for all the tabs

Wed, 10 Oct 2012 13:19:16 GMT

Hi,

I had to open the document in QV11 to save it, and then run it in QV10 as usual.

The information I can see in log file is not so complete like you get when there is no hidden script but it could help.

Thanks a lot for your answer