topic Re: Issue with omit feild option in section access in QlikView

Issue with omit feild option in section access

Wed, 11 Dec 2013 12:19:17 GMT

Hi,

I had a problem with omit field option in section access.

Consider the following scenario,

I will omit a particular field for a user using the section access for a document, close document and close qlikview.

Then I will open the document as that user and I will see that the field is omitted.but as I reload the document the omitted field is getting displayed.

Is there any method to prevent this action on reload ?

Thanks in advance.

Re: Issue with omit feild option in section access

etay_netintent — Sat, 28 Dec 2013 20:26:20 GMT

Hello

Section Access is activated when you open the model.

Close the model and open it again.

The same is seen with Section Access reducton - after you reload, and before you close and open the model there is no reduction.

Good Luck

Re: Issue with omit feild option in section access

qlikpahadi07 — Sun, 29 Dec 2013 08:03:27 GMT

Hi,

I think Etay has already highlighted all points it's exactly the same Section Access will work when we open that Document and you also can restrict User to reload so only Admin with login ID/Pass can reload with full access.

Re: Issue with omit feild option in section access

Colin-Albert — Sun, 29 Dec 2013 12:12:46 GMT

Do you have the check boxes for "Initial reduction based on section access" and "strict exclusion" enabled in the document properties?