topic Re: Dynamically setting read-only property in QlikView

Dynamically setting read-only property

Wed, 27 Aug 2014 08:26:41 GMT

Hi,

I have a question about setting the read-only property on a conditional basis. I have a pivot table which if clicked loads a pop-up of detailed information about the relevant record.

In my case I want this pop-up to be prevented if the user is not assigned the required privileges.

Can this be done?

Thanks!

Re: Dynamically setting read-only property

marcus_sommer — Wed, 27 Aug 2014 09:28:31 GMT

Are the data really confidental you need section access - if not you could make a condition over osuser().

Introduction to Section Access

http://community.qlik.com/blogs/qlikviewdesignblog/2014/05/26/section-access

- Marcus

Re: Dynamically setting read-only property

Wed, 27 Aug 2014 12:45:25 GMT

Thanks Marcus, I will refer this article.