topic Re: Guage Chart in QlikView

Guage Chart

Tue, 23 Dec 2014 07:06:03 GMT

Hi all,

As shown in below image I have used 3 segments in Guage chart ranging from 1 to 95 (Red) 95-97 (Amber) 97-100(Green)

I need to show the needle in red part ,but when i select autowidth Segment needle stays at same position

I need to show needle in red Area even if i make autowidth segments ,can i do this ,is there any solution??

Kindly reply ,in case of clarification revert.

Re: Guage Chart

sushil353 — Tue, 23 Dec 2014 07:29:32 GMT

Hi,

Need position is determined by the expression you are calculating..

since the value of your expression is 90 so it is aligned to that position..

Is there any specific need to have your needle in Red position.. ?

~Sushil

Re: Guage Chart

manojkulkarni — Tue, 23 Dec 2014 07:34:35 GMT

Needle position is always determined by your expression value.

Re: Guage Chart

mdmukramali — Tue, 23 Dec 2014 07:38:30 GMT

Dear,

The Needle Position based on the your expression value.

if value below >95% then it will be in Red segment.

can you attach the sample data. so that we can help in better way.

Thanks,

Mukram

Re: Guage Chart

jyothish8807 — Tue, 23 Dec 2014 07:41:37 GMT

Hi,

PFA.

Over here you can change the needle position by selection any value from the list box. You can do the same in your scenario or try to implement some set analysis to set the needle to a particular value.

Regards

Re: Guage Chart

Wed, 24 Dec 2014 01:39:47 GMT

Hi Sushil,

Yes need to show the red region minimum,I dont want to change expression i juz need to show amber and green area size more

Re: Guage Chart

Wed, 24 Dec 2014 01:41:49 GMT

Hi,

where to find your attached sample file?

I dont want to change my expression ,my need is to show amber and green area in large size which you can see in image is in very smaller size,with same expression

Re: Guage Chart

jyothish8807 — Mon, 29 Dec 2014 05:32:28 GMT

Hi Rohit,

You can increase the size of green and amber part by changing the lower bound for each segment.

go to Presentation Tab -> un tick Auto width Segment option on the bottom->select each segment and set lower bound of your choice.

Hope it works.

Regards