topic Re: Report Editor - Table Fit-to-Width in QlikView

Report Editor - Table Fit-to-Width

pover — Fri, 19 Feb 2010 02:42:04 GMT

How do can I make a table to fit the width of the page if the page is a multi-page? The "fill" and "fill with aspect" option don't seem to work like when it is not a mult-page. Any ideas?

Thanks, Karl

Report Editor - Table Fit-to-Width

Fri, 19 Feb 2010 02:54:32 GMT

I've had a similar problem and had to use a work-around as setting the print settings to 1 x 2 pages.

It seems as if your object is narrow enough, multi page is fine. But if your object is (too) wide, you can't use 'clip' and fill/ fill with aspect fill only the current sheet.

Report Editor - Table Fit-to-Width

pover — Fri, 19 Feb 2010 17:30:03 GMT

That will have to work for now. Thanks, Matt.

Re: Report Editor - Table Fit-to-Width

Thu, 27 Sep 2012 10:13:53 GMT

hi,

I had the same problem with my object on the report. and this solution worked fine for the big charts. but my chart can always have a diffenrent width. and when the chart is a little bit smaller it stretches it out on the whole page and I dont want that. I have tried a kinds of settings but I didnt find a solution. either the small chart is streched out or the big chart need ceverall pages because of the width.

does anyone know a solution for this problem?

regards,

Re: Report Editor - Table Fit-to-Width

gines_rueda — Fri, 11 Oct 2013 11:46:28 GMT

Hello,

You could try with the option "Scale To X %" in the same place.

Regards,

Ginés.

Re: Report Editor - Table Fit-to-Width

gines_rueda — Fri, 11 Oct 2013 11:50:54 GMT

Hello,

The two ways I have found for this are the options:

Scale to X % (you have to select the scale carefully.

The option as you have said fit to pages (but if you document fill more than 2 pages do not work either, the limit you can put in this option is 1 x 2000 and it works for any number of pages between 1 and 2000.

I have chosen the second one with that limit.

Regards.

Ginés.