topic How to define a short static step in a large slider in QlikView

How to define a short static step in a large slider

Hatus — Thu, 12 Aug 2010 10:33:37 GMT

Good day everyone,

I am struggling to find out how I can set a very short step ( 0.5) for my slider (from 0 - 30'000). The slider in this case leads the max. value shown in a line chart.

Unfortunately it takes a minimum step of 100. How can I change this?

Thank you

Hatus

How to define a short static step in a large slider

johnw — Fri, 13 Aug 2010 00:36:00 GMT

In the general tab, put a checkmark in "Static Step" and enter 0.5?

But unless your users have a monitors 60,000 pixels wide, a static step of 0.5 seems meaningless, since they can't control the cursor that precisely. It's still going to jump by at least tens, simply because that's how big a pixel is.

AW:Re: How to define a short static step in a large slider

Hatus — Mon, 16 Aug 2010 07:45:52 GMT

I apreciate your reply John.

I tried already to mark the static step with 0.5 but it staied the same. In the shorter sliders it works like expected.

if this option is stil limited, I will think in another way to solve it.

Regards

Hatus