topic General Script Error (Logfile attached) in QlikView

General Script Error (Logfile attached)

helen_pip — Thu, 14 Jul 2016 09:49:27 GMT

Hello

I am getting a general script error when running a QVW on the QEMC

Could someone kindly take a look at the log file and advice where I may need to concentrate my efforts to resolve this issue

It may be worth mentioning that prior to this error message I was getting "Did not recognise connector reply", which I believe is now fixed

It may also be worth mentioning that the pathway to store the QVW works O.K.

And the script takes 2 hours to run- so could it be a timeout issue?

Kind Regards

Helen

sunny_talwar — Thu, 14 Jul 2016 09:52:36 GMT

Things to make sure:

1) Is the path correct?

Q:\DEVELOPMENT\InfoQlik\QVD\OP_main_data.qvd (qvd)

2) Do you have writing access to this path?

3) Make sure the file is not in use

helen_pip — Thu, 14 Jul 2016 09:55:22 GMT

Hello Sunny

I have just tested on a days worth of data and the data gets stored into the QVD O.K.

It may be worth mentioning that the script can take up to 2 hours to run, so I am wondering if it is timing out.

Do you know where I could change the timeout for a QVW?

Kind Regards

Helen

awhitfield — Thu, 14 Jul 2016 10:00:08 GMT

Hi Helen,

it looks like you are using a path to a mapped drive in the script, this won't work when reloading from QMC, it needs to be the full UNC path.

HTH

Andy

sasiparupudi1 — Thu, 14 Jul 2016 10:03:49 GMT

use it like

\\yourserver\c$\DEVELOPMENT\InfoQlik\QVD\OP_main_data.qvd (qvd)

makrishnaraj — Thu, 14 Jul 2016 10:04:49 GMT

Hi Helen,

The error could be because of the insufficient storage memory in that drive or the QVD is in use by other application at the time of storing

Hope this is helpful

helen_pip — Thu, 14 Jul 2016 10:23:25 GMT

Hi Andy

Thank you, I think this may have solved it!

I will find out in 2 hours from now, when it has finished running on the QEMC