Script shows Script Finished while in debugger, but comes up with Failed message when Close button in debugger is clicked

vvira1316 — Tue, 22 Nov 2016 20:21:04 GMT

Hello,

Any help/guidance on the scenario

I'm not running into failed message if I've following code, as can be seen from Table viewer snap, but ......check Label "ERROR SITUATION" below

If _DateField='Request Date' Then
        RENAME Fields [$(_CalendarPrefix)DateText$(_CalendarSuffix)] to [RD DateText]; /*,
         [$(_CalendarPrefix)Year$(_CalendarSuffix)] to [RD Year];   */
   End If

I'm running into failed message while debugging script that contains following code that is part of a subroutine even though it shows Script Finished in debugger. Failed message appears after Script Finished message in the debugger.

Label "ERROR SITUATION"

If _DateField='Request Date' Then
RENAME Fields [$(_CalendarPrefix)Year$(_CalendarSuffix)] to [RD Year]; /*

[$(_CalendarPrefix)DateText$(_CalendarSuffix)] to [RD DateText]; */
End If

Thanks,

Vijay

Re: Script shows Script Finished while in debugger, but comes up with Failed message when Close button in debugger is clicked

vvira1316 — Tue, 22 Nov 2016 21:20:54 GMT

I found a work around to avoid situation that was causing it.

topic Script shows Script Finished while in debugger, but comes up with Failed message when Close button in debugger is clicked in QlikView

Script shows Script Finished while in debugger, but comes up with Failed message when Close button in debugger is clicked

Re: Script shows Script Finished while in debugger, but comes up with Failed message when Close button in debugger is clicked