topic Re: Default selection issue in Access Point. in QlikView

Default selection issue in Access Point.

renuka_sasikumar — Thu, 09 Nov 2017 18:59:08 GMT

Hi,

I have one qvw where there are many sheet in which each has some or the other trigger onopen sheet.

Issue:

When I open the qvw in the Server normally how we do it then the default selection is visible but when I open this qvw in Access Point there is no default selection (onopen sheet trigger) but when I go to the neighbor sheet & again jump on the same sheet that time I am getting the default selection.

Any help on this as its little urgent.

Thanks in advance!

Renuka Sasikumar

Re: Default selection issue in Access Point.

renuka_sasikumar — Tue, 14 Nov 2017 07:34:25 GMT

Hi,

Did anyone came across this issue, as it is little urgent for me.

Thanks in Advance

Renuka S

Re: Default selection issue in Access Point.

sampada0810 — Tue, 14 Nov 2017 07:58:19 GMT

Try making selections on Access Point, for the first time, then close the qvw and again open.
The selections should be visible.

Re: Default selection issue in Access Point.

tresB — Tue, 14 Nov 2017 08:42:45 GMT

May be you need 'Document Event Trigger' ->OnOpen instead?

Re: Default selection issue in Access Point.

madhumitha — Tue, 14 Nov 2017 09:12:26 GMT

Hello Renuka,

What you have done is sheet level trigger.

What you need to do is both Document level trigger and sheet level trigger.

Document level trigger helps to make default selections on reload/opening of the document.

Then you can have a consistent default selection with the help of Sheet level trigger.

Hope this helps!