how to pass in a parameter to variable

gerrycastellino — Tue, 21 Apr 2015 23:51:18 GMT

I have a variable defined as below, how do I replace the [s_DB_reg1] which is a state with a parameter which will hold the state.

LET MA.SA.conf.expr.v.Tier1_Risk_Based_Capital_Ratio_Base_Num ='sum({$<REGULATORY_SCENARIO={ "' &chr(36)&'(=only({[s_DB_reg1]} REGULATORY_SCENARIO))" }>} AMOUNT, 0))';

I've tried to replace as follows, but does not work - &chr(36)&'1 which will expand to $1

LET MA.SA.conf.expr.v.Tier1_Risk_Based_Capital_Ratio_Base_Num ='sum({$<REGULATORY_SCENARIO={ "' &chr(36)&'(=only({

&chr(36)&'1} REGULATORY_SCENARIO))" }>} AMOUNT, 0))';

I would call the variable as $(MA.SA.conf.expr.v.Tier1_Risk_Based_Capital_Ratio_Base_Num ("[s_DB_reg1]") ??

Re: how to pass in a parameter to variable

Gysbert_Wassenaar — Wed, 22 Apr 2015 09:04:22 GMT

Try:

LET MA.SA.conf.expr.v.Tier1_Risk_Based_Capital_Ratio_Base_Num ='sum({$<REGULATORY_SCENARIO={ "$' & '(=only({$' & '1} REGULATORY_SCENARIO))" }>} AMOUNT, 0))';

topic Re: how to pass in a parameter to variable in QlikView

how to pass in a parameter to variable

Re: how to pass in a parameter to variable