Autonumber() in Incremental Loads

Mon, 23 Mar 2015 15:58:14 GMT

We are trying to use autonumber() with incremental loads. On the initial load, we have the field with the autonumber() working fine.

Autonumber	Field1
1	A
2	B
3	C
4	D

However, we want to keep the autonumber() continuing on subsequent incremental loads from where it last left off; so it would start the next with 5. Is this possible with the autonumber() function?

Re: Autonumber() in Incremental Loads

sunny_talwar — Mon, 23 Mar 2015 17:09:25 GMT

Are you doing a autonumber on Field1? If yes then you can try the following:

I have not tried it, but what if you create a variable, lets say vCount

count:

LOAD Count(AutoNumber) as AutoNumberCount

Resident yourTable;

LET vCount = Peek('AutoNumberCount')

and then in your incremental load do AutoNumber(Field1) +$(vCount) as AutoNumber, but do this on a resident load table with a where condition specifying Where not Exists(Field1).

Again, I have not tested this, but I feel a variation of this should work for you.

Best,

Sunny

topic Autonumber() in Incremental Loads in QlikView

Autonumber() in Incremental Loads

Re: Autonumber() in Incremental Loads