Single Configurator - Selecting Dimension Value

williamlau — Wed, 25 Nov 2020 16:16:04 GMT

I have 2 bar charts in which I created URLs for with the Single Configurator tool. The measures used in the charts are the same between the two. In the first chart, I specified Region as the Dimension and there are only 5 values. Very simple. In the other chart, I am using Store Numbers. There are over a 1000 stores.

With the first chart, I created a URL and I specified in the URL which Region I want to filter on. I copied and pasted the URL into a browser and it works fine.

With the second chart, I created a URL and I specified the Store Number that I want to filter on. I copied and pasted the URL into a browser. The chart appears in the browser but the selection was not applied.

If I were to open up the original dashboard, I can make these selections without any problems.

Is there a limitation on the number of values in a Dimension when using the Single Configurator?

Re: Single Configurator - Selecting Dimension Value

Qrishna — Sat, 03 Mar 2018 08:29:16 GMT

hi - i tried with my QS Single config, and works fine for me.

If I understood you well, you want to from a Single Object page be able to influence selections in another Single Object selection page!?

You can do that with the identity parameter by passing the same identity to all your Single Object pages.

example:

let's say you have 2 iframes on different pages

by adding the identity=[some_id] parameter to both, you will be able to reflect selections from the first object to the second one.

topic Single Configurator - Selecting Dimension Value in QlikView

Single Configurator - Selecting Dimension Value

Re: Single Configurator - Selecting Dimension Value