Qlik Community

New to Qlik Sense

Discussion board where members can get started with Qlik Sense.

vinay_bangari
Valued Contributor III

Binary Load

Can we do a binary load of a qlikview app ( i mean QVW file)  which has section access in it into QVF .

1 Solution

Accepted Solutions
shree909
Valued Contributor II

Re: Binary Load

HI Vinay, If you have a section access in the qvw files, you cannot do binary load on qliksense. Even if the script runs, it throws an error, data is not loaded from the qvw. Thanks

5 Replies

Re: Binary Load

Maybe this is helpful: Qlik Sense substitute for BINARY load.

- Marcus

vinay_bangari
Valued Contributor III

Re: Binary Load

Thank you marcus_sommer i will check that and update the thread. Thanks for your fast reply

vinay_bangari
Valued Contributor III

Re: Binary Load

marcus_sommer   it gives me the process of how to do Binary load which i knew already. But there are some points which i don't know earlier have learnt from the thread you referred too. But my question was if a QVW file has section access in it can we do Binary load in QVF file

Re: Binary Load

AFAIK there are some differences between qlikview and qlik sense in the way how section access is implemented. Therefore I'm not sure if it in general would be possible respectively it might depend on various details like if NTNAME is applied or USERID and PASSWORD and/or if strikt exclusion is enabled.

Would it be possible (maybe in a copy) to remove the section access?

- Marcus

shree909
Valued Contributor II

Re: Binary Load

HI Vinay, If you have a section access in the qvw files, you cannot do binary load on qliksense. Even if the script runs, it throws an error, data is not loaded from the qvw. Thanks

Community Browser