This field is required.
Only these extensions are allowed(.jpg, .JPG, .jpeg, .JPEG, .gif, .GIF, .png, .PNG)
Tags cannot contain the characters ' /, \\, #, ?, or ; >,< '
Only these extensions are allowed(.zip,.ZIP,.pdf,.PDF,.qvf,.QVF,.qvw,.QVW)
If you’re new to Qlik Sense, start with this Discussion Board and get up-to-speed quickly.
I have two tables [Stage 1] and [Stage 2].
I have to concatenate [Stage 2] to [Stage 1], I wrote the following commands but in the result, the values from [Stage 2] is not showing.
First I wrote this
Concatenate ([Stage 1])
[Stage 3]:Load *Resident [Stage 2];
Drop table [Stage 2];
After that i wrote this
[Stage 1]:Load *Resident [Stage 1];Concatenate ([Stage 1])Load *Resident [Stage 2];
But in both cases, I am just getting from the stage 1 and stage 2 values are missing, but when I run them separately it works fine.
To investigate more add flag field while concatenate then check
[Stage 1]:Load *,
'Stage 1' as FlagResident [Stage 1];Concatenate ([Stage 1])Load *,
'Stage 2' as FlagResident [Stage 2];
What is the use of flag?