Qlik Community

New to Qlik Sense

Discussion board where members can get started with Qlik Sense.

smatsuyama
New Contributor II

Is there any way to changing Qlik Sense port 4242?

Hi, Please let me know about my question.

Our customer using Juniper Software for VPN connection.

They want to introduce Qlik Sense, but the port that Juniper is using is same port of Qlik Sense 4242.

They can not introduce Qlik Sense. Is there any way to change the port 4242?

4 Replies
erikadvectas
Valued Contributor

Re: Is there any way to changing Qlik Sense port 4242?

No. As you may see within the QMC, a few of the other services can have the port changed. The Repository service cannot, there are no settings available for this.

Regards,

Erik

smatsuyama
New Contributor II

Re: Is there any way to changing Qlik Sense port 4242?

Thank you Erik. I understood.

We hope to co-exist the both products if it is possible.

MVP
MVP

Re: Is there any way to changing Qlik Sense port 4242?

Hi,

Sorry to bump this old thread but I just run into this and I think it's worth sharing.

You can make it work as long as you stop all Juniper services, then install Qlik Sense, make sure they start and run fine, license the Qlik Sense server, then restart the Juniper Services.

Miguel

smatsuyama
New Contributor II

Re: Is there any way to changing Qlik Sense port 4242?

Hi,Miguel.

Thank you for your reply.

I tried the way you showed me. However, it did not work unfortunately.

We are using a [Juniper Network Connect Service].

At the same time, I can start-up with both services of Qlik Sense and Juniper Network Service. However, the connection will fail if I try to run a VPN connection.

Currently, I have gained the answer with the corresponding is difficult from Juniper Network and QlikTech.