Qlik Community

New to Qlik Sense

Discussion board where members can get started with Qlik Sense.

ltillemans
New Contributor III

Labeling names to geopoints

Hello,

For a client ,I need to plot the bus locations and the stops of the busses on the map in Qlik Sense 2018 april release.

I did that, by using the gps long and latitude info.

But when you hover over the datapoints you see the Geocode instead of the names of the buslocations?

How can I label the bus locations with the right names? I need to do the same with the bus ids.

I searched online but so far I have not found an answer.

Thanks in advance,

Liesbeth

1 Reply
plu
Contributor III

Re: Labeling names to geopoints

Hi Liesbeth,

In your layer in the map there are two sections used for this.

Within the "Data" section you use the field/dimension that is the name of the location

Data.PNG

Within the "location" section you use the field(s)/dimension(s) that is for the position

location.PNG

And the tooltip will then show what is in the data section

Tooltip.png

Regards,

Patrik.