Qlik Community

New to Qlik Sense

Discussion board where members can get started with Qlik Sense.

r_sam-sin
New Contributor

Launch a sheet with 2 initial selections in the same dimension

Hi Guys,

On a sheet load I need a filter to be set as Client Status = 'A' and 'B' (In this case only active Clients will show). Therefor I am using the Climber Selection bar but here only one initial selection is possible or am I wrong? So how can I open the sheet with an initial selection of two of the three values of a dimension?

Thanks in advance.

1 Solution

Accepted Solutions

Re: Launch a sheet with 2 initial selections in the same dimension

Hi Robbert, the extension allows to set a separator for many values, default separator is comma, so you can set the value as:

A,B

4 Replies

Re: Launch a sheet with 2 initial selections in the same dimension

Hi Robbert, the extension allows to set a separator for many values, default separator is comma, so you can set the value as:

A,B

r_sam-sin
New Contributor

Re: Launch a sheet with 2 initial selections in the same dimension

Thanks Ruben,

I was constantly doing it between single quotes since it were words.

It works!

Thanks!

lanlizgu
Contributor

Re: Launch a sheet with 2 initial selections in the same dimension

Hi Ruben


I am experiencing the same issue, but when I add to the initial selection the two values I would like to get 40575,40576

I get an error in the expression. The initial separator is also set as a comma.

Thank you.

lanlizgu
Contributor

Re: Launch a sheet with 2 initial selections in the same dimension

I got it, I had to add '40575,40576'.

Thank you

Community Browser