Qlik Community

New to Qlik Sense

If you’re new to Qlik Sense, start with this Discussion Board and get up-to-speed quickly.

Announcements
Read about the latest Qlik Community enhancements on the Community News blog!
cancel
Showing results for 
Search instead for 
Did you mean: 
Carlaf_93
Creator
Creator

Problem with coordinates in map

Good morning,

 

I'm trying to plot some point's layer on the map with coordinates.

 

 [coordinates] :

LOAD * INLINE [
LAT, LONG,  AREA,
46.2143, 11.1197, A];

But in the map nothing is displayed. The map doesn't understand the formet.

How should i write it?

 

Thanks.

1 Solution

Accepted Solutions
Gui_Approbato
Creator III
Creator III

Hello,

Try replacing dots with comma and changing the delimiter. Use this instead:

 [coordinates] :

LOAD * INLINE [
LAT ;  LONG;  AREA
46,2143 ; 11,1197 ; A ]   (delimiter is ';') ; 

 

and you can add a Geomakepoint() to translate that to coordinate point on your table:

[coordinates] :

LOAD  Geomakepoint(LAT,LONG) as Coordinate, * INLINE [
LAT ;  LONG;  AREA
46,2143 ; 11,1197 ; A ]   (delimiter is ';') ; 

Then you can use the Coordinate field in your map too

View solution in original post

1 Reply
Gui_Approbato
Creator III
Creator III

Hello,

Try replacing dots with comma and changing the delimiter. Use this instead:

 [coordinates] :

LOAD * INLINE [
LAT ;  LONG;  AREA
46,2143 ; 11,1197 ; A ]   (delimiter is ';') ; 

 

and you can add a Geomakepoint() to translate that to coordinate point on your table:

[coordinates] :

LOAD  Geomakepoint(LAT,LONG) as Coordinate, * INLINE [
LAT ;  LONG;  AREA
46,2143 ; 11,1197 ; A ]   (delimiter is ';') ; 

Then you can use the Coordinate field in your map too

View solution in original post