Qlik Community

New to Qlik Sense

Discussion board where members can get started with Qlik Sense.

awadah25
Contributor

QlikSense Could not Reach http://localhost:4848/hub with error (-102).

how can I solve the following issue:

Could not Reach http://localhost:4848/hub with error (-102).

I can't open Qlik sense on my desktop

1 Solution

Accepted Solutions

Re: QlikSense Could not Reach http://localhost:4848/hub with error (-102).

This can happens when the QlikSense Desktop is trying to do things before other things have fully initialised.

Often if you simply leave the error up, count to 5 and press <F5> to refresh all is ok as all will have fully initialised.

3 Replies
ahaahaaha
Honored Contributor

Re: QlikSense Could not Reach http://localhost:4848/hub with error (-102).

Re: QlikSense Could not Reach http://localhost:4848/hub with error (-102).

This can happens when the QlikSense Desktop is trying to do things before other things have fully initialised.

Often if you simply leave the error up, count to 5 and press <F5> to refresh all is ok as all will have fully initialised.

wolfkat12
New Contributor II

Re: QlikSense Could not Reach http://localhost:4848/hub with error (-102).

I had the same issue and F5 and other suggestions in the forum (repair installation, check LAN settings and bypass proxy for local addresses) did not work.

It looks as if some settings on the corporate network blocked this address.

The solution that worked for me: launch Qlik Sense desktop while not on the corporate network, then connect while the desktop is open.

Community Browser