Qlik Community

New to Qlik Sense

Discussion board where members can get started with Qlik Sense.

Announcements
See why BI users voted Qlik #1 in 11 categories. GET REPORT
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Creator
Creator

Straight table in QlikSense

What is "Show Column if" option which is available under dimension in straight table ? What it is intended for ?

1 Solution

Accepted Solutions
Highlighted
Partner
Partner

it is use for conditnal hide and show
suppose you have column zone and need to display colmun when only zone has selected.

GetSelectedCount(Zone)>0

Also refer thread.
https://community.qlik.com/t5/New-to-QlikView/Conditional-show-hide-columns-based-on-contents-of-ano...

Thanks & Regards,
Arvind Patil

View solution in original post

5 Replies
MVP & Luminary
MVP & Luminary

To show or hide the column based on the result of the expression specified for calculating the true or false result that is used to show or hide the column


talk is cheap, supply exceeds demand
Highlighted
Partner
Partner

it is use for conditnal hide and show
suppose you have column zone and need to display colmun when only zone has selected.

GetSelectedCount(Zone)>0

Also refer thread.
https://community.qlik.com/t5/New-to-QlikView/Conditional-show-hide-columns-based-on-contents-of-ano...

Thanks & Regards,
Arvind Patil

View solution in original post

Highlighted
Creator
Creator

But when I select a option "NO" then the column should hide. In that case why am I getting an error "Calculation Condition not Fullfilled" ?  But the columns gets hidden as well. When I check the edit mode I am getting such error kind of... Is there anything which has to be taken care off from my end for this warning  ?

Highlighted
Partner
Partner

What is your condition ?

It is simply shows your condition has not fulfilled.

Thanks & Regards,

Arvind Patil

 

Highlighted
Creator
Creator

When I select "Yes" the columns should show and if its "No" it has to hide. When I select "Yes" I don't get this message. But when I select "No" it is showing up.

My condition is , " Flag='Yes' " in the "Show Column if"