Discussion board where members can get started with Qlik Sense.
Is there a better way to use GetFieldSelections in an Set Analysis than this:
All the '"'& is a bit ugly in my opinion, but it works.
Go to Solution.
* Try to put the double-quote around the $(...) :
* Your value separator is "," and not , ?
Thanks for the reply,
I haven't tried your answer, because I ended up with a different solution. Forgot the set is applied for the entire HyperCube and not by rows.
I used '","' to get the result of "DimValue01","DimValue02". It worked, but wasn't pretty.