Qlik Community

New to QlikView

Discussion board where members can get started with QlikView.

Announcements
Make your voice heard! Participate in the 2020 Wisdom of Crowds® Survey. BEGIN SURVEY
datagrrl
Contributor III

Changing "QV engines for distribution" setting. What to do?

Hello-

I am planning on changing this setting in QMC. For now I am going to stay below the number that would require me to edit the registry. My plan is to go from 4 to 8. I am fine on the resources side as well.

Do I need to restart any services after I make this change?

Should I do any specific backups prior to making this change? Normally if I am making a change to the configs I make backups, but I wasn't sure since this was in QMC if that was required.

Any feedback is appreciated.

1 Solution

Accepted Solutions
Highlighted
Support
Support

Re: Changing "QV engines for distribution" setting. What to do?

Hi Randi,

You should be fine with 8 QV Engines. No, there isn't a need to restart the QV services after adding additional engines and I don't foresee the need to make an additional backup of %ProgramData%\QlikTech directory.

Hope this helps and ping back if you have further questions.

- Chip

Sr. Technical Support Engineer with Qlik Support

View solution in original post

2 Replies
Highlighted
Support
Support

Re: Changing "QV engines for distribution" setting. What to do?

Hi Randi,

You should be fine with 8 QV Engines. No, there isn't a need to restart the QV services after adding additional engines and I don't foresee the need to make an additional backup of %ProgramData%\QlikTech directory.

Hope this helps and ping back if you have further questions.

- Chip

Sr. Technical Support Engineer with Qlik Support

View solution in original post

Highlighted
datagrrl
Contributor III

Re: Changing "QV engines for distribution" setting. What to do?

Thanks. That worked.