Skip to main content
Announcements
Have questions about Qlik Connect? Join us live on April 10th, at 11 AM ET: SIGN UP NOW
cancel
Showing results for 
Search instead for 
Did you mean: 
Deepak13
Contributor III
Contributor III

General Script error

Hello All

While reading data from QVDs I am getting the "general script error".

below is the log related to the same script.

 

LEFT JOIN (MAINTABLE)
LOAD ABC as ABC,
EFG as EFG
FROM $path\XYZ_DIM.FULL.qvd(qvd)
2 fields found: ABC, EFG,
1,325,426 lines fetched
Joining/Keeping
General Script Error
Execution Failed
Execution finished.

1 Solution

Accepted Solutions
Deepak13
Contributor III
Contributor III
Author

Checked the data model, there were circular loops in it, removed them, issue is fixed.

Thanks for the suggestion

View solution in original post

9 Replies
ramasaisaksoft

Hi Deepak,

 

 

I Have couple of guesses on this General Error:

load application under debug mode  10 records each 
load tables one by one (probably also in debug) and see where the error incurs
Some times Join also cause  
does it always happen on the same table? if you change the order of loading?
do you have the rights to read in the database?

So please check all these conditions else if possible share entire Script so that our folks will help you ASAP.

 

Deepak13
Contributor III
Contributor III
Author

Thanks for replying Ramana

No, this is the first time i am facing this issue.

There were few changes i made in the script:

1) added a table to pull few columns from it

2) added 2 additional columns from an existing QVD

Geeks
Contributor II
Contributor II

Please put ; after From statement and try loading

Deepak13
Contributor III
Contributor III
Author

I checked the script and already have ; after the from statement
Frank_Hartmann
Master II
Master II

is there any message during script reload if you put:

Set ErrorMode =1;

at the beginning of your Load?

Deepak13
Contributor III
Contributor III
Author

I can see Set ErrorMode =2 in the log of QVW that failed. What does it mean??

Frank_Hartmann
Master II
Master II

Somewhere in your script is the following line :

Set ErrorMode = 2

Change it to

Set ErrorMode = 1

and have a look at the errormessage appearing when reloading script!

 

From Qlikviw Help:

ErrorMode 

This variable determines what action is to be taken by QlikView when an error is encountered during script execution. 

By default (ErrorMode=1) the script execution will halt and the user will be prompted for action (non-batch mode). 

By setting ErrorMode =0 QlikView will suppress all error messages on failure to load. If script execution is halted due to failure, it will not continue.

By setting ErrorMode =2 QlikView will trigger an "Execution of script failed..." error message immediately on failure, without prompting the user for action beforehand. 

Example:

 set ErrorMode=0;
andrei_delta
Partner - Creator III
Partner - Creator III

hello, 

try give the fields other names then the one they already have

Deepak13
Contributor III
Contributor III
Author

Checked the data model, there were circular loops in it, removed them, issue is fixed.

Thanks for the suggestion