Qlik Community

New to QlikView

Discussion board where members can get started with QlikView.

anothergreg
New Contributor III

Single click drillthrough on stacked bar chart

I would like to have my QlikView exhibit drill through to the cross-section of Dimensions in a single click on my Stacked Bar Chart.  For example (see picture) I have two dimensions, one being MonthName and another being Status.  I would like to be able to drill right into the cross-section of the segment I select, so for example if I pick the green portion of the top bar, I am selecting both January 2019 and "Completed, Reviewed, Signed Off" and both dimensions have been drilled immediately.  Currently if I click any of the segments of any of the bars I get brought to that month with all Status values available and then I have to click again in order to get to the Status I would like to select.thatsstackedupyo.PNG

2 Replies
ramasaisaksoft
Valued Contributor III

Re: Single click drillthrough on stacked bar chart

Hi Anothergreg,

I don't know , why you want to combine two different type of Dimension s into single Dimension?

Hope fully you created ,

[Month Name] Dimension from your Master calendar Table

and 

[Status]  Dimension from Some Status related table

so it is not recommended to combine these 2 fields into 1 field,if we did any thing like this may be we will get wrong count /Mismatch of data

any way try like this if you have any chance do like  :- [Month Name] &' '& [Status]  as [Status Month] ,but drill down time hopefully it will show mismatch data.

correct me if i misunderstand your requirement

Highlighted
anothergreg
New Contributor III

Re: Single click drillthrough on stacked bar chart

I haven't combined two dimensions into a single dimension.  My bar chart is a stacked chart which has 2 unique dimensions, and I want to keep this format.  The issue I'd like to resolve is that when I click on a specific segment of my bar chart, I would like it to filter on both the Month and the Status at the same time rather than just the Month.  So, for example if I clicked on the red piece of the bar chart for January 2019, currently it will just show me all of the statuses for January 2019.  And if I clicked on the green piece of the bar chart for January 2019, again it will show the same drill of all statuses for January 2019.

I would like the chart, when I click on the red portion of the January 2019 bar, to filter on both January 2019 as well as Initiated Status.  And from the same example in the paragraph above, if I click on the green portion of the January 2019 bar, I would like it to then filter on January 2019 but also Completed,Reviewed,Signed Off Status.