I've 2 list boxes in the attached app.
requirement is I need to restrict the Value(3) in listbox for Country(AUS).
I've tried with below exp
It seems fine but if I select Value(3) its not giving as I expected.
where I did wrong in my expression??
can some one help me out in this.
Thanks for the response.
I've tried with same in Country list box as well.But still no luck.
I've been facing same problem even if implemented in Country list box.
Can you suggest how to overcome in this??
What is the issue you are facing. For me when i select AUS the value shows 3. Then i clear the selections then selected 3 then AUS showed up in Country. Check below:
If this is not what you looking for please elaborate your expected output.
Apologies for the delay.
"What is the issue you are facing. For me when i select AUS the value shows 3. Then i clear the selections
then selected 3 then AUS showed up in Country."
Here don't clear the selections.
do the below steps:
Select Country AUS in list box.
Now we will be able to see only 3 in other list box(Value)
and select 3 in Value listbox(don't clear the selections)
and see the results as I showed the results in above screenshots.
Also I've tried along with Pick and Match in Value list box in below.
my desired output should be in the below snapshot, it should show only 3 in Value list box.
and after immediate selections in Value list box 3 then it should show(Greyout) corresponding Countries as shown in below.
implemented same in other list box(Country) But still no luck.
Please correct me if anything wrong.
not sure if this meets your requirement but give it a try.
go to settings --> Document Properties --> Triggers
then go to:
"Field Event Triggers" select Coutry and choose "On Select" -->Add Actions --> Add --> Selection -->Clear Field --> Value
then do the same with Value Field:
"Field Event Triggers" select Value and choose "On Select" -->Add Actions --> Add --> Selection -->Clear Field --> Coutry