Discussion board where members can get started with QlikView.
is it possible to have a reference line similar to the one in the attached chart?
about the chart:
horizontal stacked car chart,
dimension = geographic address and Time
expression = 1/60 to represent minutes
bar colour expression = avg(speed)
the chart is uses the colour of the bar to represent speed each minute across the day and select location.
now what i would like is a reference line (or similar) that for example starts at 10 oclock at site M55/5248K and ends at 2 oclock.
is this possible?
So do you want a vertical line at 10 and another at 2?
If so then you should just be able to define a couple of reference lines as normal (I think!)
You can add reference line in bar graph under Presentation in reference line section based on the condition, refer screen shot below for info.
Hope this help
thanks for the responses, im familiar with the reference lines however if you look in the image this isnt quite what im after.
its not looking like its possible without an extension i was wondering if anyone had any ideas,
Sorry that was a part of my response, the image doesn't really make it clear what you're after.
So its not a line at 10 and 2, do you want to fill each bar with red between 10 and 2?
abit of background to explain a little better.
the chart represents speed along a road, at various locations there are message signs that switch on and off at certain points. i want my line to represent them switching on and off.
i could change the colour of the bar to represent this however im working to a spec and have to deliver certain functionality.