Qlik Community

Qlik GeoAnalytics Discussions

Discussion Board for collaboration regarding Qlik GeoAnalytics.

mdepauw2
New Contributor II

Is there really a way to debug GeoAnalytics lookup?

Hi,

I am trying to use the lookup service to display figures per ADM2 areas in France.

bugsaone.png

The warning on the top left of the map does not help figuring out a potential mismatch: it only indicates 'Unsuccessful location lookup (...)' without any more precision (I am on November 2017 release, I have seen a video from earlier version which gives some precision but those precisions have disappear).

As a result, I cannot display 2 ADM2 areas: "Saône-et-Loire" and "Haute-Saône" as seen on this image.

It all looks like the fields which are used by the GeoAnalytics to make a match are not available using the Load function by the way.

So, I have no idea of what to use to make a 'Manual remap' as the extension parameter would allow...

Could you help?

Best,

Manuel

1 Solution

Accepted Solutions
paul_scotchford
Valued Contributor

Re: Is there really a way to debug GeoAnalytics lookup?

Hi Manuel,

Select your map and open the Interaction and Controls drop down, then check Log Level to be Debug, then you will see a more detailed log (drop down) of the Lookup failure.

Paul

3 Replies
yannick_allard
New Contributor II

Re: Is there really a way to debug GeoAnalytics lookup?

Hi Manuel,

GeoAnalytics is a javascript extension. I usually open the app along the Chrome development tool (or Firefox Firebug) and first look into the console logs. You can also search from where the exception is coming. However, it requires some knowledge of javascript and general notion of javascript debugging within the browser.

There is nothing more available in the moment as far as I know.

Good luck

Yannick

paul_scotchford
Valued Contributor

Re: Is there really a way to debug GeoAnalytics lookup?

Hi Manuel,

Select your map and open the Interaction and Controls drop down, then check Log Level to be Debug, then you will see a more detailed log (drop down) of the Lookup failure.

Paul

mdepauw2
New Contributor II

Re: Is there really a way to debug GeoAnalytics lookup?

Hi Paul,

thank you very much! This is exactly this.

Best regards,

Manuel

Community Browser