Qlik Community

Qlik GeoAnalytics Discussions

Discussion Board for collaboration regarding Qlik GeoAnalytics.

Employee
Employee

Manual Remap in QlikSense: works in Bubble Layer but not in Chart Layer

Using the same dimension for Bubble Layer and Chart Layer I've fount out, that the manual remap does perfectly work in the first case but fails in the second.

Example:

Area Layer -> Dimension: German Administrative Regions (loaded in German); Location ID: 1 => shows German Administrative Regions  with different colors

Bubble Layer -> Dimension: German Administrative Regions; Location, Size: nothing => shows bubbles overs German Administrative Regions except for Oberfranken (Upper Franconia).

     Solution: Bubble Layer -> Location Options -> Manual Remap: "Oberfranken":"Upper Franconia" -> this solves the problem.


Chart Layer -> Dimension1 and Dimension2: German Administrative Regions; Location,Chart Values, Size: =count(PLZ) => shows Pie Charts over every German Administrative Region except for Oberfranken.

      Setting Manual Remap to "Oberfranken":"Upper Franconia" does not help.


Any ideas why MANUAL REMAP works in the Bubble Layer and does not work in Chart Layer?

QGA Version:  GeoAnalyticsForQlikSenseServerNo5.8.1

Qlik Sense: 3.2 SR4

1 Solution

Accepted Solutions
Employee
Employee

Re: Manual Remap in QlikSense: works in Bubble Layer but not in Chart Layer

Hello Denis,

You are right, the manual remap is not working for some layers. This behavior will be fixed with GeoAnalytics next release.

In the meantime I suggest to do this "remapping" when you load your data, if possible.

If you don't want to lose your original value, you can create another field with the recoded location names and use these directly as location input for GeoAnalytics layers.

Thanks, best regards.

Ana Yakushi

Qlik GeoAnalytics

2 Replies
Employee
Employee

Re: Manual Remap in QlikSense: works in Bubble Layer but not in Chart Layer

Hello Denis,

You are right, the manual remap is not working for some layers. This behavior will be fixed with GeoAnalytics next release.

In the meantime I suggest to do this "remapping" when you load your data, if possible.

If you don't want to lose your original value, you can create another field with the recoded location names and use these directly as location input for GeoAnalytics layers.

Thanks, best regards.

Ana Yakushi

Qlik GeoAnalytics

Employee
Employee

Re: Manual Remap in QlikSense: works in Bubble Layer but not in Chart Layer

Hello Ana,

thank you very much for your answer and hints.

kind regards,

Denis

Community Browser