Qlik Community

Qlik GeoAnalytics Discussions

Discussion Board for collaboration regarding Qlik GeoAnalytics.

rammuthiah
Contributor II

how to work with Bubble and heat map?

I added bubble chart and heat map using Qlik GeoAnalytics. Measure for Bubble chart is working fine. And while adding measure for Heat map makes invisible on heat map. Can anyont explain on how to work with Bubble and heat in a single map with steps?

1 Solution

Accepted Solutions
Employee
Employee

Re: how to work with Bubble and heat map?

The url is typically the address to a web service that supplies geodata, here's one example;

Setting up a WMS as a background map in Qlik GeoAnalytics

The animator is very straightforward, just pick the dimension you want to iterate over.

4 Replies
Highlighted
Employee
Employee

Re: how to work with Bubble and heat map?

Hi Ram,

That should work, the heatmap layer and bubble layer has almost the same properties.

Please check out the "Heatmap example"

Qlik Sense Guides & Examples «  bi.idevio.com

Qlik GeoAnalytics for Qlik Sense reference documentation

Thanks,

Patric Nordström

Qlik

rammuthiah
Contributor II

Re: how to work with Bubble and heat map?

Thanks Patric, I have gone through the reference manual. It was helpful and I have one more doubt that what needs to give in the URL for Geodata Layer. How to work with Geodata Layer and Animator. How to create the animator. Awaiting for your reply..

Employee
Employee

Re: how to work with Bubble and heat map?

The url is typically the address to a web service that supplies geodata, here's one example;

Setting up a WMS as a background map in Qlik GeoAnalytics

The animator is very straightforward, just pick the dimension you want to iterate over.

rsing122
New Contributor

Re: how to work with Bubble and heat map?

@Patrick - The examples in the link  you shared for 'Heatmap Example' is throwing an error. any clue why?

Community Browser