Qlik Community

Qlik NPrinting Discussions

Discussion Board for collaboration on Qlik NPrinting.

Highlighted
innashna
New Contributor

NPrinting job is not running automatically

Hello,

we have a scheduling for NPrinting job and we have the following issues. Manually I can run this job. But when I ran it automatically it gets stuck, while NPrinting service seems to be up. Please see the log:

Service  5/15/2019         7:00:00 AM        Message           Service: event started

Service  5/15/2019         7:00:00 AM        Message           Run Schedule: Schedule_AvgStationReport

Service  5/15/2019         7:00:00 AM        Message           Run Job: jobSendAvgStationRport

Service  5/15/2019         7:00:00 AM        Message           Run Task: SendEmailAvgStationReport

 

The report is connected to qvw which is located on another server. QV services on this particular server run with different user than NPrinting service. But, as I said manuall it runs successfully. Please advise.

Labels (2)
1 Solution

Accepted Solutions
Support
Support

Re: NPrinting job is not running automatically

Hi @innashna 

When you run manually, you likely are running from a different login account other than the dedicated NP service account.

Try logging on as the dedicated NP service account and try to run the task manually while logged on as the NP service account. If it fails, then there is a problem with the NP service account...for instance, the named QV cal associated with the NP service account may be in use by some other computer because the NP service account 'might' be getting shared with a different NP server. Or possibly the QV cal associated with the NP service has been lost. 

Check the following article for other troubleshooting solutions as well:

 
Hope this helps...
We are just 'like' you and like to be 'liked' when we provide a helpful answer and when you press the 'Solution Accepted' button if an answer provided resolves your question or issue 🙂 Cheers!
1 Reply
Support
Support

Re: NPrinting job is not running automatically

Hi @innashna 

When you run manually, you likely are running from a different login account other than the dedicated NP service account.

Try logging on as the dedicated NP service account and try to run the task manually while logged on as the NP service account. If it fails, then there is a problem with the NP service account...for instance, the named QV cal associated with the NP service account may be in use by some other computer because the NP service account 'might' be getting shared with a different NP server. Or possibly the QV cal associated with the NP service has been lost. 

Check the following article for other troubleshooting solutions as well:

 
Hope this helps...
We are just 'like' you and like to be 'liked' when we provide a helpful answer and when you press the 'Solution Accepted' button if an answer provided resolves your question or issue 🙂 Cheers!