Consumer Node - no Reload (Database connection not available?)

[sebastianfaust]

hi again,

so, after fixing the Load Balancing, i have the next "problem".

on the central node we created some ODBC connections, working fine.

now i get the message that "no default driver installed". 

i guess this happens when iam connected to the consumer node. 

on the consumer note no odbc connections are installed.  

do i have to configure odbc connections on the consumer node like on the central node, or can i apply a rule in the qmc to get that access?

thanks again

[sebastianfaust · Accepted solution]

found the solution:

https://community.qlik.com/t5/Qlik-Sense-Deployment-Management/ODBC-and-OLE-Connections-not-working-...

Re: ODBC and OLE Connections not working in Qlik Sense September 2017

Figured this out thanks to the quick help from the Qlik Support team. This was happening because the ODBC and OLE Engines were only installed on the Central Node.

Load balancing was enabled and I was being routed to a RIM node that did not have the ODBC connection or OLE Engines installed.

The solution was to install the ODBC connection or OLE Engines on all nodes.

[sebastianfaust · Accepted solution]

Figured this out thanks to the quick help from the Qlik Support team. This was happening because the ODBC and OLE Engines were only installed on the Central Node.

Load balancing was enabled and I was being routed to a RIM node that did not have the ODBC connection or OLE Engines installed.

The solution was to install the ODBC connection or OLE Engines on all nodes.