Qlik Community

Qlik Sense Deployment & Management

Discussion board where members learn more about Qlik Sense Installation, Deployment and Management.

Announcements
Customers, Partners & Luminaries only: You're invited to a Data Analytics Roadmap session. Read More
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Not applicable

How to set different workload for Rim nodes

Hi Gurus,

I've just installed QS with shared persistence. Both the Rim nodes and central nodes are added to the 'Load balancing'.

But how to track the balance among these nodes, and how to manually set the workload balance? For example, these apps should reload on this node, the others go to a different node.

Thanks~

1 Solution

Accepted Solutions
Highlighted
MVP & Luminary
MVP & Luminary

Hi,

Not sure but check below link. Hope it will help some what.

http://help.qlik.com/en-US/sense/3.2/Subsystems/ManagementConsole/Content/configure-load-balance-to-...

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".

View solution in original post

3 Replies
Highlighted
MVP & Luminary
MVP & Luminary

Hi,

Not sure but check below link. Hope it will help some what.

http://help.qlik.com/en-US/sense/3.2/Subsystems/ManagementConsole/Content/configure-load-balance-to-...

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".

View solution in original post

Highlighted
Not applicable

Hi Kaushik, thank you for the article.

In the example in the article, after I add these Production nodes into the 'Load Balancing', how to config them?

I mean could I config that certain app should only reload on a certain node?

Regards,

Highlighted
MVP & Luminary
MVP & Luminary

Hi,

Yes you can do that to, but for that you will have to right the rules.

The link has a sub link which will take you to the rules.

Regards,

Kaushik Solanki

Regards,
Kaushik
If reply is satisfactory, please "Like" the post.
If reply is solution, please mark as "Correct".